Since 1985 – Trusted Industrial Lubricant Manufacturer
PREMIUM SOLUBLE CUTTING OIL – STABLE EMULSION, SUPERIOR COOLING & LONGER TOOL LIFE
Palkut SL is a premium water-soluble cutting oil engineered to form a highly stable milky emulsion, delivering excellent cooling, rust protection, and smooth machining performance across a wide range of metal cutting operations.
Why Palkut SL?
HEAT: Non-melting up to 500C
RESIST: Oxidation and corrosion resistant
SHOCK: High shock load absorption
CHEM: Works in hostile chemical environments
Built For These Applications
Palkut SL
Download Technical Datasheet (PDF)
Products Description
PALKUT – SL is premium quality water soluble cutting oil, specially developed to form extremely stable milky emulsion even with higher water hardness level, leading to excellent tool life and finish, in all metal cutting operations, where cooling is more important than lubrication. It has excellent antirust and anti-froth quality and cause no corrosion of machine, work piece or tool. Do not decompose chemically; leave objectionable odour, cause discoluration and staining. This is operator friendly and economical in use.
PALKUT – SL is blended from refined mineral oil, emulsifier and other additives.
Procedure
- Dilution ratio with water varies between 5% to 10% depending on severity of machining.
- While preparing emulsion always add cutting oil in to water (not the other way round) to prevent inversion of the emulsion.
- Clean the coolant reservoir and system periodically, recharge the system with 1% solution of coolant to be charged and circulate for at least 1 hr. and then drain completely.
- Check the emulsion strength regularly and top up if necessary.
Performance Level
Meets IS 1115-2002 specifications.
Packing
210L, 50L, 20L
Characteristics
| S. NO. | PROPERTIES | PALKUT SL |
|---|---|---|
| 1. | Kinematic Viscosity cSt @40°C, min. | 26 – 32 |
| 2. | Flash Point COC, °C, min. | 160 |
| 3. | Copper strip corrosion test at 100% for 3 hours | 1a |
| 4. | Cast Iron Corrosion Test @3% (IP 287) | Passes |
| 5. | pH 5% emulsion in DM Water | 8.5-9.5 |
| 6. | Emulsion test, 5:1 and 20:1 ratio in water of 400 ppm hardness (as CaCO3) |
Passes (No oil or cream separation observed) |
*The specifications are subject to variations/development/customization.