Paras Lubricants - Teflon Fortified Lithium Soap Grease Manufacturer, PAL TEFLITH-NLGI  
  Home Careers Contact Us
 
 
Home About Us Products QUALITY POLICY R & D MILESTONES AMBASSADOR FAQ CONTACT US
 
Teflon Fortified Lithium Soap Grease Manufacturer, PAL TEFLITH-NLGI

HOME » PRODUCTS » Industrial Specialities » PAL TEFLITH

 
 

PAL TEFLITH-NLGI 0,1,2

 
INDUSTRIAL SPECIALITIES  

These are blends of Polytetrafluoroethylene (PTFE) fluorocarbon particles in specially prepared lithium-based, water-repellent grease. These greases are also fortified with rust, corrosion and oxidation inhibitors and additives that provide good film strength, better adhesion at high speed, under medium-to-high loads. The plating of PTFE applied to the mating surfaces under working conditions enhances the component’s life and increases re-lubrication intervals.

These greases have an application in a continuous operating temperature up to 140°C and in majority of situations specifying lubrication, especially in high pressure, water and salt-water conditions including wire ropes. Use of this grease on a continuous basis, will prevent seizing and pitting on the friction surfaces.
 
Recommended for all general purpose application in automotive and Industrial segments viz. machinery, tools, overhead garage door, channels, fan, motors, slides, gears etc. These greases have good corrosion prevention characteristics and as such finds application in marine segment also viz. cables, couplings, gears, hitches, winches etc.
 
These greases are compatible only with lithium base grease. Sealed bearings should be thoroughly cleaned before using grease described in this product bulletin.

PRECAUTION

Health: This product is not expected to produce adverse effects on health when used for the intended application. However prolonged or repeated skin contact with this grease is injurious to health. Clean properly with soap and water.
Environment: Lubricant should not be disposed in drain, soil and water.  To be disposed through licensed/authorized collector of lubricants only.

PACKING

CHARACTERISTICS

Sr. No.

Properties

PAL TEFLITH

NLGI-0

NLGI-1

NLGI-2

1.

Appearance

Red

2.

Soap Type

Lithium

3.

PTFE

3%

4.

Base Oil Type

Mineral

5.

Base Oil Viscosity, @40°C

120

6.

Viscosity Index of base oil, min.

90

7.

Cone Penetration, @25°C±0.5°C

355-385

310-340

265-295

8.

Drop Point, °C min.

180

180

180

 * The specifications are subject to variations/development/customization.
Go to Top
  Untitled Document
Automotive Engine Oils
Automotive Gear Oils
Automotive Greases
Car Care
Industrial Oils
Industrial Greases
Industrial Specialities
Pal HTG-1,2
Pal EHT-30,60,100
Pal Teflith
Palsifier-600
Pal SNG-1000
Pal Viscoin-2000
Pal Rubpro
Semi Synthetic Heat Transfer
Semi Synthetic Refrigeration
Synthetic Lubricants

Site Powered by createsoftsolutions.com